Every purchase made through our Amazon Affiliate Page helps support this site
pkinneb
-
Posts
287 -
Joined
-
Last visited
-
Days Won
18
Content Type
Profiles
Forums
Downloads
Gallery
Events
Store
Articles
Blogs
Everything posted by pkinneb
-
Welcome!
-
Welcome
-
I have a BS fence as well as a pro grip feather board that have them. Both work very well especially the feather board
-
Great job thanks for sharing!
-
Nice clean work coop! Looks awesome!!
-
I've order quite a bit from them and always been happy hopefully you have the same experience.
-
Exactly if one's not careful it can get to the point where you are overcompensating 🤣
-
A+ on the wood / grain selection on the foot board Chet!! Looking forward to following along.
-
That's all that really matters 🙂
-
Tuned out awesome Coop! Having said that $195 in finishing supplies had to hurt 🤣
-
Yes sir!! Best bang for your buck you will find.
-
I'm with Kev on Auirou rasps and would start with the two he recommends as well as add Shinto rasp. Having said that I started using rasps on my sculpted bar stools. I added a Shinto and then two Auirou's like many tools as you use them you think ya know this shape or that grain would be better suited for this and now a few years later I think I have 8 plus like 6 riflers LOL
-
Welcome!
-
I really like the leg round over detail
-
Me too!
-
I used the spray frosting (rattle can) on my theater marquee and it worked very well.
-
Drawer construction y’all will prob hate :)
pkinneb replied to Bushwacked's topic in Member Showcase
I have to admit not a huge fan but I've definitely seen much worse drawer construction, next time add a wedge or two as well 🙂 -
Review of Harvey MG-36 Miter Gauge compared to Incra 1000HD
pkinneb replied to pkinneb's topic in Shop Tools and Reviews
I think you'll be very happy Bob! While I think the price is crazy, better on sale, but still high it is a solid piece of engineering in my opinion and I will never need another. Its simple, accurate, and like Kev said the micro adjust is a game changer. -
Couldn't you use the circle jig on the bandsaw at an angle and accomplish the task? If not a router comes to mind using many small cuts.
-
I don't think the HP actually matters kickback hurts at best and is dang dangerous at worst. If you believe or determine you have a wonky board or stress in a board run it through your old friend the bandsaw 🙂
-
Very nice Coop!
-
if at all possible you also want support on both or neither sides of a HCM bit, that would be tough to do after the first plunge with a nut shape
-
...and you call yourself a woodworker 🤣 On a more serious note the cabinet looks great!! I am going to make some changes to my router table (primarily replace the top and lift) but think I will add the inserts for the bits getting them out of the plywood has always been a bit of a pain
-
Welcome!
