So I have a customer build (potentially, waiting on acceptance of quote), but have been tossing around ideas on how to cut the X section, but still not sold on 100% I like any of the ideas.
So I am curious about the bottom X's ... they are 16" deep, so thats part of the problem. I was thinking lap joints but being so deep that would be a big lap joint and I would need to cut on the bandsaw. Not sure how clean that would look coming from that ?? Although this is still my #1 idea so far.
Next thought was to just cut 1 side in half and then domino 2 sides pieces into that, but that could be way more effort and tricky alignment than needed.
Also, the other thing I wasnt sure of, should I build these 3 X's as 3 separate pieces and just sit them in there and then glue down to install? Not sure one big piece would be any better?