pkinneb Posted August 27 Share Posted August 27 (edited) Changing over my J/P has always been a bit of a pain because of the hose, well watching a Sawyer Design YouTube the other day and I see this Magport and immediately thought I needed one 🤣 Not the cheapest solution at about $70 but man it is really going to help in changeover Edited August 27 by pkinneb 4 Quote Link to comment Share on other sites More sharing options...
Kev Posted August 27 Share Posted August 27 I've seen these out there for a bit now. I just haven't looked into them because I have everything hard piped.. It's nice to see someone here using them because they make a lot of sense! 1 Quote Link to comment Share on other sites More sharing options...
pkinneb Posted August 28 Author Share Posted August 28 Agreed! If it holds up which it should since there really isn't much too them. It seals perfectly no air loss at all so that's good. This is the only tool in my shop that needs it becuase during change over I have to move the vacuum with the arm to get more slack on the flex pipe. Now I just disconnect flip to planer mode and re attach easy peasy. I could see them being really handy in a shop where you have to move between tools while using the make an instant tight seal. 1 Quote Link to comment Share on other sites More sharing options...
Bob Posted August 29 Share Posted August 29 I switched to the Magport about 4 years ago. I have one drop that services 4 machines. My jointer, planer, drum sander and 1 of my bandsaws. They are perfect for a shop with limited space. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.